PIR Motion Sensor

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low.

Red wire is power (5 to 12V). Brown (or White) wire is GND. Black wire is open collector Alarm.

This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V.

The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.

The connector is slightly odd but has a 0.1" pitch female connector making it compatible with jumper wires and 0.1" male headers.

Note: The sensor runs at 3.3V via an onboard voltage regulator which accepts an input between 5V and 12V. Some users have experienced instability in the sensor when running at 5V, suggesting the input voltage should really be at least 6V.

Documents:

Write a review

Please login or register to review

PIR Motion Sensor

  • Manufacturer: SparkFun
  • Product Code: SEN-13285
  • Availability:  4
  • £8.28

  • Ex Tax: £6.90

Related Products

Infrared Transmitter and sensor pair

Infrared Transmitter and sensor pair

Infrared Transmitter and sensor pair A spectrally matched near infrared emitter and sensor..

£1.56 Ex Tax: £1.30

Tags: PIR, Motion, Sensor. ir, infra, red, movement, detector, SEN-13285, sen-08630, alarms, SparkFun,